Results 1 to 5 of 5

Thread: engine pinging -- Detonation?

  1. #1
    Inactive Member randomwalk101's Avatar
    Join Date
    July 19th, 2000
    Posts
    1,344
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Question

    Although I don't think my engine pings at 12 degress, I'm just wondering if there is a way we can connect a small led somewhere that would light up whenever the engine pings (ei. whenever the knock sensor kicks in or whatever)....What wire to tap into and where?

    I think this is much better than the "listening" method. If you have J&S safeguard, you're just lucky. I think EVENTUALLY I'll get one too smile

  2. #2
    Inactive Member Bigkat's Avatar
    Join Date
    November 25th, 1999
    Posts
    601
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    RW101 - Here is a device from MSD(Engine Knock Alert - PN #8964).

    pn8964 7

    The price over on carparts.com is $170.87(get 33% off from importhook.com...cost should be just under $135 shipped)


  3. #3
    Inactive Member randomwalk101's Avatar
    Join Date
    July 19th, 2000
    Posts
    1,344
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    BigKat, thanks for the tip. The unit only show you when ping occurs and nothing to prevent it? I mean if that's all it does, then $13x is a little too much. I would shell out a little more and get the J&S safeguard which retard timing and show you when detonation occus on its dual monitor if I were to spend that much. What I have in mind here is just a simple led tap into some sensor wire ... but I guess it's not possible frown

  4. #4
    Inactive Member ringer's Avatar
    Join Date
    October 21st, 1999
    Posts
    76
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    randomwalk101: the j is about $500 so you'd be spending a LOT more than the $135 for this thing.
    Also, I don't see why you couldn't try your idea with the LED...it wouldn't be hard to just tap into the wire at the ECU.

    [This message has been edited by ringer (edited August 28, 2000).]

  5. #5
    Senior Hostboard Member rjaffey's Avatar
    Join Date
    February 16th, 1999
    Posts
    764
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    The signal is more complex than just a voltage which can light up an LED. The sensor is actually in effect a microphone and the signal a data stream, which requires computer analysis to look for the correct sound patterns.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •